cannot use wingate...

[maxim2004]

hi support...
i just d/l wingate and install it....
my computer can't browse internet and use any internet connection....why???? does this computer (192.168.0.1) have to set any dns,gateway??? until i uninstall wingate, everything's back, internet connection is available.....

i've switched back to 5.23 version, and it's still block my connection too....what mistack i've missed??? do u have any step by step tutorial???

thank you

[genie]

Make sure that the adapter usage was set properly (internal/external).

[maxim2004]

yep....adaptor setting is fine....

just install and connect to the internet....the computer which install wingate should browse web instantly, right????

do i have to set gateway proxies???

[genie]

Yes, the computer on which you install Wingate should work fine - what are the netwrok cards installed on this machine and how are you connected to the internet?

[maxim2004]

connect through isdn dialup....

can u explain in detail how to use wingate..?? since the installation....

do u have any instant messaging software???? i want to talk with u...

[genie]

ICQ 4096585

[maxim2004]

another question....do i have to install wingate client on every computer in my lan????

another question...what is user in wingate for???

another question...what if through my isdn connection, i got private ip addess, i.e. (172.17...) and with external gateway (203.....) assigned... does wingate figure this out which gateway should it use...i saw that wingate use the (172.17...) one....

thank you in advance

u reply so fast....

[maxim2004]

one moment , i'm d/ling icq...

[genie]

Ok, one by one:

1. No, you don't. Client machines can use NAT or proxies. There are pros and contras in using WGIC clients, one of such contras is the requirement to install WGIC clients.

2. I am afraid I didn't quite follow it - any user or one particular user?

3. Did you mean that your WG machine had 2 default gateways? Normally the topology like yours works just fine - when the new IP address is allocated WG re-loads the routing table and all routing is done through the newly allocated gateway. However, WG might not recognize the adapter as an external one propely - make sure that the usage is set correctly.

[maxim2004]

can u answer me via icq?