Dialer disabling after restarting engine

[dominic]

I downloaded the latest version of wingate today and have set up 2 dialers and enabled them, however when I shutdown and restart the Wingate engine they are disbled again and I have to re-enable them. Is this because I only have the trial version? If so can I activate Wingate to test it on a PC in my office and then re-activate it when I get to the customers site?

[Nev]

Hi, no it should not disable the dialer[s] trial or otherwise.

Yes you can install and activate it at your test site then transfer the licence after de-activating it to your customer's site.

[dominic]

Funny that, since I put up the post I purchased a license key and tried again and it all works fine now.

Thanks for the info on activation though.