Wingate y PcAnywhere

[makor]

Tengo un proxy con Wingate 5.0.1 y estoy tratando de que usuarios remotos se conecten con mi host que es PcAnywhere 10.5. Ya segui las indicaciones del documento 1049 de Deerfild.com y sigo sin poder lograrlo.
Alguien puede decirme si tiene configurado el Wingate para hacer esto o si sabe como hacerlo.
Al querer conectarme, el error que me da el remoto es el siguiente:
"Se ha producido un error de comunicaciones. No se puede conectar al dispositivo especificado. PcAnywhere sin conexion"
Si alguien me puede ayudar, se lo agradecere mucho.
Gracias[/b]

[labull]

PCAnywhere use Ports 5631 and 5632 by default.

If your PCAnywhere host is behind WinGate, you must open these Ports in ENS and map them to the host IP address.

If you are using PCAnywhere to connect to host outside through WinGate, these port must be open in ENS.

Larry

[makor]

But it didn`t work.
Now, after a few changes, when I try to connect the remote, I got the following message:
"End of session" after its connected. It connects the host, but inmediately shows this message and close the window.
Thank you very much.

Alejandro

[labull]

Alejandro,

Do you see the connections in GateKeeper?

5631 should be a TCP connection and 5632 should be a UDP connection.

Larry

[makor]

Larry

I made a mistake writing the TCP port number. I wrote 5361 instead of 5631. I saw that when I was checking the ports numbers, as you told me.
Thank you very much.
Regards,

Alejandro

[labull]

Does it work OK now?

Larry

[makor]

Thanks

Alejandro