Allow Certain IP Ranges

[mcb]

I have had several instances where intruders have made it past the firewall.

How do i limit it where only only certain ip ranges can access the Wingate Server to make it out to the WAN?

Thanks,

Matt

[adrien]

Hi

When you say made it past the firewall, do you mean they gained access when a port was blocked?

Or was the port they used open?

You can use the policies in the ENS to determine who can make NAT connections.

Adrien

[mcb]

it was a port that Wingate didn't specifically have closed (port 1080, socks proxy to be specific). I then closed it in ENS.

I have experiemented with the Policies in ENS and have never gotten them to work. [For instance i tried to apply a policy where only certain ip's could gain access through VNC.] Is there a type of setup that it will only work with? For instance does WGIC have to be on client computers or some sort of authentication in place?

I do not employ WGIC or authentication. We just use NAT.

How in my case could you use policies to limit this?

I apologize for all of my questions. I recently took over as admin for a small company. They have had Wingate in place for several years. I am at an inherent disadvantage of understanding how it works in our network since i did not set it up.

I do read the help documentation and the forums have been most helpful.

Thanks,

matt