LAN without internet after ADSL router change

[MatrixCyber]

Hello there.

I recently changed my router to other that has wireless capacity. This new router is configured in router mode, so all connections to wireless PCs are working pretty well.
The problem I got is over the LAN. Before I was using another ADSL router, without the router capacity activated, and using the dial method in order to connect to my ISP. Wingate 5.0.7 had no problem with that, and the LAN was working fine using NAT and ENS activated.

Now, with this new router connected to the server Wingate, I lost completely any internet connection in the LAN and even in the very same Wingate Server PC. The funny thing is that if I disable the Wingate Engine, I have internet on Server PC without any problem, but not in the LAN, obviously.

This is my configuration on Server PC:

Ethernet card to switch:

IP Address: 192.168.0.13
Subnet Mask: 255.255.255.0
Default Gateway: -

--------------------------------------
Ethernet card connected to the Zyxel P-600 router:

IP Address: 192.168.1.10
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.1


Any clues so I can solve this issue?

[jasona]

Can you please check that WinGate has your 2 networks assigned correctly? An important part of your WinGate installation is to check how the network cards are detected. The Network card / Modem pointing towards the Internet should be marked as External. The network card pointing towards the LAN should be marked as Internal.

Please see the following Knowledge Base article for the location to set Internal/External.

http://support.qbik.com/index.php?_a=kn ... ails&_i=57