Installed 5.0.10 Now NAT is not working

[g1]

I was using 5.0.7 and everything was working fine, including NAT. I uninstalled 5.0.7 then installed 5.0.10 and now NAT no longer works.

Please see my NAT log below, notice that the destination port is always 0:

11/04/03 04:37:44 192.168.0.1 Guest 0000000004 Requested: NAT: UDP 192.168.0.1:123 <-> 207.46.130.100:0
11/04/03 04:38:14 192.168.0.1 Guest 0000000021 Requested: NAT: TCP Connection to 64.37.156.21:0
11/04/03 04:38:16 192.168.0.1 Guest 0000000004 Traffic 76 0 0 76 32s
11/04/03 04:39:11 192.168.0.1 Guest 0000000021 Traffic 144 0 0 144 57s
11/04/03 04:39:48 192.168.0.1 Guest 0000000033 Requested: NAT: UDP 192.168.0.1:123 <-> 207.46.130.100:0
11/04/03 04:40:21 192.168.0.1 Guest 0000000033 Traffic 76 0 0 76 33s
11/04/03 04:40:33 192.168.0.9 Guest 0000000034 Requested: NAT: TCP Connection to 204.176.49.2:0
11/04/03 04:41:14 192.168.0.9 Guest 0000000034 Traffic 0 0 0 0 41s
11/04/03 04:42:51 Service started

What can I do to fix this (Other than reinstalling 5.0.7)

Thanks
Ron

[genie]

Is firewall switched off in ENS properties?

[g1]

Yes the firewall is disabled

[genie]

Aye, there is a known issue with disabled firewall. The problem is fixed in the upcoming release.

[g1]

Ok, thanks for the info.

[g1]

Ok I enabled the firewall at its lowest setting and everything is working.

( I use a different firewall than wingate's built in firewall )