i can't connect VPN Server with Cisco VPN Client

Jan 27 04 1:33 am

I need connect to VPN Server locate to internet, but Cisco VPN Cliente can't connect, but WGIC intercept connection y show error : error to connect Wingate Server 166.114.x.x when Wingate Server is 192.168.0.1.

WGIC take VPN Server ip address like Wingate Server.

I used UDP Protocol.

How start NAT in wingate server, if NAT is working y can connect to VPN Server when WGIC is disabled.

Regards.
_________________

Jan 29 04 4:45 pm

To enable NAT, you need to have the ENS installed. If this is not currently the case, re-run the WinGate installer to do so. You then just need to make sure that your client machines behind WinGate have their DNS and Default Gateways (configured in the TCP/IP properties) set to the internal IP address of the WinGate server.

Regards

Neil