how can i setup Paltalk

[zxzxa]

how can i setup wingate to use Paltalk

[Pascal]

http://www.paltalk.com/PalTalkSite/supp ... rksup.html

That gives you tips on what you need to do. Now, more information always helps:

What version of WinGate are you using?
How are your clients configured to connect out through WinGate? (NAT, proxy , WGIC, etc.)
What error messages / problems have you encountered?

[zxzxa]

What version of WinGate are you using?
WinGate 5.2.3

How are your clients configured to connect out through WinGate?
proxy

[Pascal]

Have you setup any of the mappings required by PalTalk? (Under the section "Ports used for PalTalk" in their configuration guide).

Your easiest option to get that to work might be to use WGIC - as that will automatically listen and connect as required.

[zxzxa]

no i did not.
what you min????????

[Pascal]

Okay. There are certain ports (As per the guide released by them above above) that PalTalk needs.

Your easiest option to get that working would be to install WGIC on the client. Alternatively, you need to setup a number of TCP and UDP mappings for that to make it work. (Effectively creating a series of proxies)

Unless there is a way to run PalTalk through SOCKS or something similar? (Don't have PalTalk, can only go on what they say on their website)

[Pascal]

Neil tested it yesterday - you need to use WGIC or NAT for it to function properly.

yeah i tried it yesterday, worked great through nat straight off the bat, theres no proxy option in its settings though............ so it would have to be NAT or WGIC

[zxzxa]

thanksssssssssss it is good naw