DHCP not working

[Cartm4n]

I upgraded to the new version of wingate, and the DHCP no longer works. It will not let me put anything in the "binding" tab, so therefore it cannot run. If what I just said makes any sense, can someone please tell me how I can get it working again?

Thanks.

[neil]

If no interfaces appear in the Bindings tab under the DHCP properties, this is because WinGate either hasn't detected, or doesn't belive you have any 'private' interfaces. What IP range are you using on your internal network!? You should also check in Gatekeeper under Options - Advanced -Network Interfaces that your internal NIC has been set to 'private' and 'trusted'.

Regards

Neil